Smart TV Magic Remote

Instruction

Register the remote

1, Plug the USB receiver into TV’’s USB port, connection image is appeared on the screen.

2, Press the “WHEEL (OK)” about three seconds, LED will light.

3, Point the remote at the USB receiver, LED will flash three times and then go off,

registration is completed, pointer is appeared on the screen.

* With a few TV sets, if there is no response when plug into a USB port , please tryanother USB port.

About Pointer

If you want to display the pointer on the screen again, please press the “POINTER KEY” You can shake the remote slightly from right to left to control the direction. If you pressDIRECTION KEYS (UP/DOWN/LEFT/RIGHT) while the pointer is in use, the pointerwill disappear from the screen.

C As a normal IR remote (deregister the remote)

Press and hold the HOME & BACK KEY @AcK at the same time about five seconds towithdraw the match of remote with your TV, LED will flash three times and then go off. MagicRemote will operate like a general IR remote control.When registration is completed, DIRECTION KEYS (UP/DOWN/LEFT/RIGHT)VSCROLL UP  , SCROLL DOWN , WHEEL (OK)，,SETTINGS , POINTER KEY are but other function key still retain to use IR

Method of Learning Function for STB

Those keys can learn from Set-up Box Original remote control: STB PWR，LVE ZOOM ,MOUSE, STB MENU ,SETTING Keys. After finishingregistration, except MOUSEKEY, IR learning function also can be used by those keys

1, Press HOME G and SETTING into the learning mode.

2, Put the receivers towards each other, the distance must be 2-5cm.

3, Press the key need to learn from RM-18, LED will be flash.

4, Press the corresponding key from Set-up Box original remote, LED will flash 3 times then

keep lighting.

5, Keep going to learn other key.

6, When finish learning, press “HOME” to exit and save.

Warm tips

*Pressing and holding BACK key can exit all the menu interface.